H2Ocala · Horse & Home Water
Well water smells like rotten eggs? Check the hot and cold taps first
A rotten-egg smell in well water often points to hydrogen sulfide or sulfur-bacteria activity, but the first useful distinction is whether the odor is in hot water only or in hot and cold water. Smell a glass from a cold tap and then a hot tap; if only hot water smells, the water heater may be the source, while odor in cold water points toward the well, plumbing, or treatment equipment. Penn State Extension and the Minnesota Department of Health describe these pathways and recommend locating the source before choosing treatment. [1] [2]

Quick answer
Why does my well water smell like rotten eggs?
A rotten-egg smell in well water is usually hydrogen sulfide, a gas that can come from the groundwater, from sulfur bacteria in the well or plumbing, or from a reaction inside the water heater. The smell is often strongest when a tap first runs or when you use hot water, and the water can also taste sulfury or "off." To tell where it starts, smell a glass of cold water and a glass of hot water away from the sink drain. If only the hot water smells, look at the water heater first. If both do, the well, plumbing or treatment equipment is the likelier source. [1] [2]
The short answer
Start here
- Hot water only: Ask a licensed plumber or the water-heater maker about the heater, including its magnesium anode. Do not remove or change a part yourself unless the responsible professional says it is appropriate. [1] [2]
- Hot and cold: A well, plumbing line, softener, or other treatment equipment may be contributing. A certified laboratory test can help select treatment; the test must be suitable for hydrogen sulfide because the gas can be lost from a sample. [1]
- What will not fix it: A normal water softener is not a hydrogen-sulfide treatment. It exchanges hardness ions; it is not a substitute for treatment selected from test results. [1]
Try this first: a free hot-versus-cold check
This is a screening observation, not a test and cannot identify a contaminant or prove that water is suitable for drinking.
The Minnesota Department of Health uses hot/cold taps and whether the smell lessens after running to locate the likely source. [2] A drain can smell independently of the water, so use a glass.
After the water has been sitting for a while, run a cold tap into a clean glass and smell the glass away from the drain.
Run a hot tap by itself and smell a separate glass.
Repeat at another indoor fixture. If available, compare an outdoor tap that is upstream of treatment equipment; do not dismantle plumbing or enter a well pit.
Note which taps smell, whether the odor fades after several minutes, and when it began.
Decision table: what the pattern suggests
| What you notice | What it may suggest | Appropriate next step | Can a softener alone fix it? |
|---|---|---|---|
| Hot water only; cold water does not smell | Water-heater chemistry or bacteria in the heater; a magnesium anode can contribute to hydrogen-sulfide formation | Licensed plumber or water-heater maker evaluates the heater and warranty | No |
| Hot and cold water smell at several fixtures | Hydrogen sulfide or sulfur bacteria in groundwater, plumbing, or treatment equipment | Certified lab and qualified well-water professional identify the source and treatment | No |
| Odor only at one fixture, and the glass water is fine elsewhere | Fixture or drain issue rather than the whole supply | Plumber evaluates the fixture/drain; do not infer a well problem | No |
| Odor is less noticeable after running water | Possible stagnation or sulfur bacteria in plumbing; this observation is not conclusive | Record the pattern and ask FDOH-Marion or a qualified professional whether testing/disinfection is appropriate | No |
| Odor began after well, pump, plumbing, filter, or softener work | The work or opened system may have changed the water system; FDOH says disinfection may be needed after work | Contact the responsible licensed professional and FDOH-Marion; test before making treatment claims | No |
What the smell usually means
Hydrogen sulfide is a gas associated with the rotten-egg odor. Penn State says sulfur-reducing bacteria can thrive in low-oxygen groundwater, wells, and plumbing, and that water heaters can create the odor through reactions involving sulfate and a magnesium anti-corrosion rod. [1] The Minnesota Department of Health also lists natural processes, sulfur bacteria, water heaters, and—rarely—pollution as possible sources. [2]
Do not turn this into a health conclusion. Odor is not a substitute for laboratory testing, and its absence does not establish water quality. FDOH says private-well owners should test bacteria and nitrate yearly and when taste, odor, or appearance changes. [3] Route health questions to FDOH-Marion or a certified laboratory.
What testing can and cannot tell you
The hot/cold check is a free screen for where to look first, not laboratory testing. A home strip screen does not test hydrogen sulfide, bacteria, nitrate, or a full analysis. Never call a photo, strip reading, or Hank’s interpretation a lab result or diagnosis.
Penn State notes that hydrogen-sulfide testing may need to occur at the home or require chemical stabilization before shipment because the gas can change or escape. Ask a certified lab whether it offers a suitable hydrogen-sulfide method and what sample-preservation instructions apply. For routine private-well concerns, FDOH recommends annual bacteria and nitrate testing and testing when odor changes. Florida DEP maintains a search for certified laboratories. [1] [3] [4]
If a laboratory finds coliform or E. coli, follow FDOH guidance. FDOH says disinfection may address bacteria causing unpleasant tastes and odors, but disinfection will not correct nitrate, fuel, pesticides, or a damaged/improperly located system. FDOH also directs owners to have water tested by a certified laboratory after disinfection before using it for drinking, cooking, ice, or food preparation. [5]
What removes hydrogen sulfide
Treatment depends on measured results and water chemistry, not odor strength. Penn State describes activated carbon, aeration, oxidizing media, and chlorination or other oxidation-plus-filtration approaches, each with maintenance or chemical-handling requirements. [1]
What will not fix it
A standard softener alone. It is designed for hardness exchange, not hydrogen sulfide. Penn State notes treatment equipment can also provide an environment favorable to sulfur bacteria in rare cases. [1]
Guessing from a photo or odor strength. A photo cannot measure gas concentration or determine whether the well, heater, plumbing, or treatment equipment is responsible.
Shock chlorination as a lasting permanent cure. FDOH and Penn State describe disinfection for appropriate bacterial situations; Penn State notes sulfur-bacteria odor can return. Route the decision and retesting to FDOH-Marion or a licensed well contractor. [1] [5]
Boiling or filtering by guesswork. Do not claim either addresses this problem or bacteria/nitrate without a source and laboratory-specific advice.
When this is not H2Ocala work
Hot-only odor: licensed plumber or the water-heater manufacturer.
No water, low pressure, sputtering, pump cycling, or a pump that will not stop: licensed water-well contractor.
Positive coliform/E. coli, suspected contamination, or drinking-water health question: FDOH-Marion Environmental Health, 352-622-7744, and a certified laboratory. Do not make a health or animal-health determination.
Nitrate or infant-use question: FDOH and a certified lab; do not interpret or prescribe a response.
Animals or livestock: veterinarian for animal-health advice.
Well-pit or confined-space entry: do not enter; use a qualified well professional. [2]
What H2Ocala may honestly offer
For hot-and-cold odor, H2Ocala may review observations, an existing laboratory report, equipment photographs, and treatment goals, then prepare a written proposal for a qualified installer to size and maintain. This is not a lab test, health determination, well/plumbing diagnosis, or permit decision.
Questions people ask
Quick answers
Why does my well water smell like rotten eggs?
Usually because of hydrogen sulfide, a gas from the groundwater, sulfur bacteria in the well or plumbing, or a reaction in the water heater. It can make the water smell and taste sulfury. Compare a glass of hot and a glass of cold water: hot only points to the water heater; hot and cold points to the well, plumbing or treatment equipment.
What should I check when well water smells like rotten eggs?
Odor alone cannot answer a drinking-water question. Follow FDOH-Marion and certified-laboratory guidance; test for bacteria and nitrate as recommended, especially after an odor change. [3] [5]
Why does only my hot water smell like sulfur?
A water heater can generate hydrogen sulfide through reactions involving sulfate and its magnesium anode. Ask a licensed plumber or the heater maker to evaluate it. [1] [2]
Why does only one faucet smell like rotten eggs?
Compare a glass from that fixture with another tap. If only one fixture is affected, have a plumber assess the fixture or drain; this check does not prove the well is uninvolved.
Will a water softener get rid of sulfur smell?
No. A conventional softener is not a hydrogen-sulfide treatment. Treatment should follow suitable laboratory testing. [1]
What test should I ask for when well water smells like sulfur?
Ask a certified lab which hydrogen-sulfide method and preservation rules it uses, and ask FDOH-Marion about bacteria and nitrate testing. [1] [3] [4]
What should I do if my water smells like rotten eggs?
Only a certified lab test can tell you what's in your well water. The Florida Department of Health can help you find a certified lab.
Sources
Public guidance behind this page
- [1] Penn State Extension, “Hydrogen Sulfide (Rotten Egg Odor) in Water Wells”
- [2] Minnesota Department of Health, “Hydrogen Sulfide and Sulfur Bacteria in Well Water”
- [3] Florida Department of Health, “Private Well Water Testing”
- [4] Florida DEP, “NELAP Certified Laboratory Search”
- [5] FDOH, “Well Disinfection”